Home Creators Posts Import Register Favorites Logout
haven't archived this post yet. have a subscription? use the importer!

Content

Thanks for the feedback to my last post, it really helps. Sound quality has been an issue on many of my videos and feedback confirmed it could be improved. I will be showing my process for creating Filament Friday in the future but I'll let everyone know now, that it all starts and ends with my iPad. Filming, editing, image capture, timelapse, sound recording all start and end with my iPad.

Tinkercad/Simplify3D screen capture is typically done on my iMac but the rest is all iPad (and once in a while a little iPhone). I've tried different microphones and the Blue Snowball mic has been my go to. It plugs into the iPad lightning connector using an adapter and is powered from the iPad. It produces great sound and I use it for voice over. I can review video without unplugging it and I also have it just off camera for Filament Friday clips taht are behind the bench.

I don't like to show the camera on screen and the Snowball works best if its within 12-18" of the person speaking. So I've been boosting the sound, as its much further than that, and have been getting mixed results. It sounds great on my iPad but I noticed it sometimes gets altered by the compression on YouTube which is beyond my control.

For several videos last year I tried a wired Lavalier mic clipped on my shirt and the sound was great quality but every time I tilted my head down it got too loud and also it picked up my breathing too much. I tried different positions but I really just didn't like it on me. I then hid it in a hole in my bench and that worked great. You couldnt see it and it picked up the sound perfectly. That is unless I slide a print or my hand or a printer over the hole. Then the sound went muffled.  

I chose a wired Lavalier because I didn't want to worry about batteries dying mid-filming and I don't want signal interference from any equipment running. I had a long extension for it so it worked fine. Then I decided to hang it from the ceiling just out of view. That seemed to be better but before I could put it to good use, I tripped on the temporary cable routing and broke the mic. I was so frustrated I said screw it and decided to go back to the snowball and see if anybody noticed. 

For many videos it wasn't and issue. Then a few comments started to pop up and then a few more and so your feedback confirmed I need to improve sound. So I bought another wired Lavalier and I'll hang it from the ceiling and work on getting the sound quality to where it should be. I can see a few 3D prints will be helpful in getting this setup to keep the cable off the floor and away from my big feet.

Files

Previews only

Comments

Bob Camp

Do you have the Snowball set to omni or to cardioid? Omni will pick up a bit more room noise. Neither setting is as good as a proper shotgun pattern mic for taking out the room noise.

3D Print Creator

Hi Chuck, Do I understand that you use an extension cable on your unbalanced 3.5mm microphone? If so, you could improve a lot by changing that. Long lengths of unbalanced cable work as an antenna for interference and this can (or will) decrease the quality of your audio signal on the cable. If you have a way of using XLR cable (balanced) to get from the recorder to where you want the mic to be, then interference in cancelled and only the signal will get to your recorder. You could take a look at a wireless solution with a receiver that has an output on a short TRRS cable. This can be inserted in older models iPhone of iPad, or you can use an Apple converter in the lightning plug to use the TRRS input. This is my line of business, if you wan't I can help you with tech specs, etc. Just let me know.