Home Creators Posts Import Register Favorites Logout
haven't archived this post yet. have a subscription? use the importer!

Content

I actually ordered an E3Dv6 clone but got a v5 clone instead which is about 10 mm longer. The cooling nozzle length was too short so I had to modify it in Tinkercad. I also had to wrap the hotend block in insulation and kapton tape to prevent the fan from cooling it. The firmware doesn't have the pwm cooling fan port enabled so I ran the fan from constant 12v. This video is the result. Definitely getting better prints and still under $200. I tightened up the chassis base. All the screws/nuts were loose. Next I'm printing anti-z wobbling couplings. http://www.thingiverse.com/thing:808509

Files

Previews only

Benchy Test

Final print on reworked $154 3D printer