The Suburban Saga (Patreon)
Content
The whole issue centered on the power steering in the 1999 Chevy Suburban. It got where it was kicking back and so, on the advice of both a mechanic and some community forums, we installed a bypass kit to ditch their EVO system; a variable valve controlled by information on speed and steering wheel acceleration. Apparently this system was so hated it lasted only 3 years or so.
Well, without that valve, anything over 2,000 rpm would do two things:
1. over-pressurize the lines making steering sensitive
2. create excess heat
Well 1 was noticeable but really not that bad once you got used to it. Kinda go-carty.
2 was trickier because it took time to cook. So we thought we had to car running fine. Drive around town, do 70mph for 20 minute spells... no trouble. Then we would leave town and blammo, steering failures.
This resulted in lots of attempts to fix various parts: ball joints, steering gear, power steering pump, lines, etc.. And worse yet, because of the sustained heat some of those parts really were breaking. Which only reinforced that, once were were home and they were swapped, and the car was driving normally again... the problem must be solved!
Head out of town again... blammo. Rinse and repeat until I'm pulling my hair out. Now, for you the reader, this seems like a simple answer. But from our perspective it was a nightmare of "everything has been replaced or upgraded." Finally though, I got fixated on the heat as a culprit and walked the problem backwards. I realized with NO valve the pressure was directly tied to RPMs and, well you get the idea.
So with no real time I bit the bullet and hit the mechanic. 0 parts available to replace this valve AND with him doing the digging there are some mechanic notes that the 97 and 98 valves are dangerous in their own right. So that means I had to stalk the junk yard once a week for the past month for a 1999 Chevy Suburban. Period.
Well I got lucky the day of the hurricane evacuation notice and spent about 12 hours ripping one from a junker and getting it seated in mine. This should take about an hour, maybe 2.
You know the Midas Touch? I have Sodom's Touch. Everything I touch turns to shit. My pulley tool broke when no one was open... so I had to repair it a bit to pull and cobble together a pusher... which also broke... etc and so forth. Every step was basically complicated by some other breakage or unwaveringly determined bolt.
In the end the new valve is in, along wit a fresh steering sensor. Total cost maybe $100 and -10 sanity. Huge savings to the budget though. Of course, with all the highways routed for evacuation and weather going nuts, I haven't had a chance to do any sustained testing. First chance I get I'm taking a road trip.
I promise you now, if THIS hasn't resolved the matter I'm selling the lot and buying a newer model. I just hate to waste funds on something fixable. While we're doing very well NOW thanks to you all and the fundraising, there have been many, many weeks of C&Rsenal production where I struggled for the gasoline to get to the range to film. I won't soon forget to be thrifty.