Piranha plant hat testing (Patreon)
Published:
2026-10-10 22:00:05
Imported:
2026-11
Content
To develop this hat, I started with a basic beanie hat with two halves. Then I lowered the bottom edge of each half into a curve that will make the mouth of the plant. From there I added a lip piece that curves down even more. It took a few attempts at trying it on to make sure the lips didn't completely engulf my face 🤣
After that was testing out the right size for the teeth and stem. The first is looking good! But it was maybe just a tad too tight on me. Which is no problem because that just means I'll label this the size smaller than me! I just need to repeat this drafting for the rest of the sizes and I'm in business 💪