Flexi Factory Imperial Dragon (Patreon)
Content
It was pointed out to me that using some filaments, the horns would sag or curl at the back causing a rough look. This update minimizes that by making them slightly thicker, and putting them at a slightly sharper angle.
Thanks
Included are 4 STL's (use the one that best fits your print bed)
*Flexi Factory Dragon Square Bed_02.stl(use this for a square print bed...Most Printers)
*Flexi Factory Dragon Wide Bed A_02.stl(slightly wider...Prusa or similar)
*Flexi Factory Dragon Wide Bed B_02.stl(even wider...good for Resin Printers)
*Flexi Factory Dragon Printmill_02.stl(straight version...only good for a printmill)
The head is able to sit up due to interlocking spikes on his back. Once printed be careful not to push the spikes too hard before you learn the proper technique especially with silk PLA, which is more brittle (think slide together rather than press together) They should loosen up as you play with it.