What causes this? 3D Print finish experiment (Patreon)
Published:
2024-07-30 22:51:52
Imported:
2026-06
haven't archived this post yet. have a subscription? use the importer!
Content
Heya folks! Nearing the last step on a new 3D Print finishing technique (no, it doesn’t involve less sanding 🤣)
But I’m noticing my print is two tone where it extrudes out from the body of the rounded part.
This has been sanded but it was evenly sanded throughout the part.
I’m assuming this is caused by how the part was printed 🤷♂️🤷♂️
Just looks interesting to me
Next up… time to get my Mr Miyagi on 😂
Files
Previews only