10ft Reprack Filament holder completed! (Patreon)

Fingers crossed will have this video edited and up later today… maybe sat morning 🤣😂

Finally got around to printing Repkords Reprack filament storage solution.

You 3D print brackets & 3d print wall cleats then use EMT 1/2” conduit pipes.

I used PETG for all of the parts printed across bambulab printer / Prusa mk4 & Neptune 4

https://www.printables.com/model/129024-reprack-open-source-spool-holder-and-storage-syste

It was about $55 for the 10ft pipes & screws

$70 for 3 rolls of petg but I didn’t use all of them for the prints

If you haven’t seen these you can completely customize to the size you need & there are a ton of community mods.

Highly recommend checking out.

10ft rack for me holds 43 rolls of filament

I might add 2 more rows below