Home Creators Posts Import Register Favorites Logout

Downloads

Content

I've had a number of requests now to release the custom "pair-of-compasses" cutter that I use to create the PTFE spacers for the SSR2 (which are of course the secret to its near silent twist action). That cutter was never actually much good, so instead I have designed a special 3D printed cutting jig, which works a lot better!

To use this jig all you need to do is make a 3mm hole in the PTFE and then clamp it in place with an M3x16mm bolt (ideally with a washer under the head). You can then easily cut out the 4 radii needed to make the upper and lower spacers.

I will of course be incorporating this into the SSR2 Alpha instructions and pack, which still isn't quite ready, so I am now aiming to put it out on 1st Feb. In the meantime, I now have a GIM6010-8 robot joint motor on my desk, so keep an eye out for a community livestream in the near future in which I will have a play with that.

Tempest

Files

Comments

Rs87

Hello struggling to get on the discord. Do you have a link?

Tempest MAx

No link, it’s automated via Patreon. DM me.

TonyC

Me too