Battery Boxes finished (at last) and interface arm. (Patreon)

Test printed the fourth revision of the battery boxes. I’ve had to cut them to minimize warping. The curved areas combined with flats is a challenge but these seem to print fine. The only tweak I may make is on the ‘hooks’ which hold them onto the foot. I think they may be a little thick and need cutting to fit properly onto the shell when the drive mechanism is fitted. Also the interface arm is printed and tested so also ready for printing. They are both I the wip folder in the Patreon early bird share as I now need to write up the instructions. Happy printing.

Mike,