Home Creators Posts Import Register Favorites Logout

Content

Wayne’s printed dome from the MKIII files, lovely print!!

Files

Comments

Dane G

very nice - any tips on settings and filament used?

Dane G

thanks so much - standard PLA, no support, 0.4mm nozzle?

Dane G

hoping to start this one later in the week!

Wayne Vyner

Hi guys. Settings were 0.2mm layer height, 10% infill, speed 36 , no supports and raft. Took aprox 216 hours.I did put a few dobs of hot glue along the inside to edge hold it onto the raft. It’s only a narrow edge and didn’t want to risk it coming off the build plate later down the track.

Wayne Vyner

Also was printed with ESUN PLA +

Damien Bouchabou

what is the 3D printer you used for this wonderfull print ?

Peter Richards

I printed at 8% infill, and no problems with strength.

Tony Wilson

Was there a filament change required? How much filament did it take? I need to upgrade my CR10S 3

Terry Dossey

Are the dome panels printed in place? I printed the 200 version in PETG, and I'm planning to have the panels open/close.

Michael Baddeley

The MKIII domes do have all panels in place. The v2 dome have the opening panels so there’s options. I may do the MKIII in the future with opening panels but it’s not critical as the v2 works fine.