Home Creators Posts Import Register Favorites Logout

Content

The final designs, ready for beta testing for the MKIII foot drive, immense update and improvement on the v2, direct drive, herringbone gears, flex rollers, quieter, smoother, easier foot shells and fixings, the list goes on. In the Patreon early bird share in the MKIII body folder! Enjoy!!

Mike

Files

Comments

Peter Richards

I wonder if resin will be stronger for the gears.

Robert McCown

Because of the heat from the motors, my ABS drive gear melted. I switched to Nylon (on the previous version) and haven't had any issues. I'll likely print these in Nylon as well.

Peter Richards

Interesting. I was thinking about trying the resin SLA printer for the gears to see how they hold up.

Smoulder

Hi all, I just got to printing the feet (working my way down), and was wondering where I find the new files on the OneDrive?

3D Printed Props

Is that the same link thats in the about section. The link I'm using only has the MKIII Dome.

William

cant find it.

William

Glad I doing the feet last.But got the motors for the feet. weather over here is to cool in NYC USA right now and want to do the parts in ABS.( for drive). for to wait doing the all other parts in PLA.

Cyber_One

Hello Micheal, How did you get L2WheelTyreFlex(x8) on to the L2WheelCore(x8). I'm starting to think my TPE is not stretchy enough.... I was able to get LTyre-Flex over LWheel, granted it was tight, can't see that coming loose any time soon :-)

Michael Baddeley

Hi Ray, it is tight and I used Cheetah at about 30% infill so I’d imagine similar stretch. The method I used was first make sure the orientation is correct. The core and tyre has a 90 degree lip at one end and a 45 degree lip at the other. Put the core in at the tyre 45 degree end(this makes pushing in easier). The lip on the core is the 90 degree one goes first. I ‘stacked’ them this way. Then I used a clamp to push them together (a vice would also work). Just trying to get the core past that first lip. It may flick our in the middle, push it to keep it straight. Once your past the lip on the tyre, I just used the clamp to slowly force the core into the tyre, and it clips into place at the end. I’ve done 16 using this method, no tears (it’s tough stuff) and no failures it’s actually easier than it sounds, just wanted to describe the whole process in detail :-) you could also try warm water on the tyres but I didn’t need to do that. Hope that helps.

Ben W Bell

Is there anything from the previous feet that is reusable? I ask as I've only just finished printing them over the last few weeks.

Michael Baddeley

Hey Ben, theoretically the omniwheel frames (the centre part) can be used and the top frame assembly with the teeth on. You could fit the whole omniwheel assembly onto this and it would fit (there’s new frame pieces) if you didn’t upgrade to the bearings and flex tyres.

LarryJ

If they are anything like the first ones, it's a fight - I used a little bit of Super Lube around the edge of the rim, but I'm not sure it helped much.

LarryJ

So the rims/tires are different? Major pain getting the first ones on...

Michael Baddeley

Yeah, sorry Larry :-( had to trim / shift to accommodate the direct gearbox..