Home Creators Posts Import Register Favorites Logout

Downloads

Content

Hey! How is going?

We spent many hours figuring out which was the best setting for the print profile of this Suko version (AMS needed) and in the end the print came out quite well.

We used a 0.4 nozzle and 0,16 layer (imagine how cool it would have been with a 0.2 nozzle and 0.08 layer!).

It made loads of poop so if you decide to print more than one i suggest to print 4 of them together to minimize the waste but keep this position upside down.

The scars on top of the head are really not so evident!

I love this little Suko.

The proportion with the King Kong of 13 cm is not perfect, to be sure that the eyes were printed properly we upscaled at 120%, but as you see in the first pic it doesn't seem soo soo wrong, does it?

Hope you like it!!

Tomorrow we start printing the SKAR KING!!!

Give us some days!

Files

Comments

Eugenesaur

Just wanted to write you about upside-down print results) Great work!

Eugenesaur

So, calculations about 0.2 nozzle 0.8 optimal in bambu studio for 4 copies on my a1 mini is 2d23h2m. With changed flushing delay profile I can reduce this time for 10 hours less, but it still a lot of time (and those changes are not supported for silk filaments, I'll use Bambu Metal as for previous models). The next step - is to reduce this time more, but I'm pretty new to 3d printing. Will do my best, but maybe someone has thoughts about this =)