Home Creators Posts Import Register Favorites Logout

Downloads

Some files exceed the archive size limit and weren't saved: 1 file. Please note these limits are in place to keep this site running long term, without costing a fortune. You can favorite the creator though, certain milestones increase the limit.

Content

So guys,

I waited to post this in order to tune some print settings.

This is not the easiest print. Needs to be done with a filament you trust and following some rules.

First of all clean the printer bed, make the calibration of the bed and make a calibration flow of the filament you are going to use.

Heath:I printed with max 45 degrees on the bed (or at least open the printer door if it is a closed one like the x1c).

If there is too warmth inside the printer the filament might over melt and function as a glue on the small parts dragging them on the bed.

For this reason I created 3 profiles:

1 . WHIPSLASH this profile isfor the fearless ones (ahaha) the brave people that trust their filament and printer. This contains the skull, the tail bone and 3 rows of bone/beads.

It is the one I used to print my Whipslash and went well (maybe i was lucky).

The beads don't have any supports and the tail and skull have manual supports I made.

This decision was made in order to make easier the cleaning. it would be a nightmare removing supports from the beads.

2 and 3. The profiles 2 and 3 are one for the beads ( that have a small brim) and one for the skull and tail (with manual supports).

This profiles are a little easier and also in case something goes wrong you can cancel the print without losing too much filament (3 to 5 grams each profile).

Print 2 times the beads row as I put just 1 row in this profile)

After you choose which profile to use and when you have printed the parts do the following:

if the beads print come as good like this one of the second profile...easy peasy and you tide the skull and tail bone at the opposite ends with a knot.

but in general...

Take the thread that you chose (I am using paper thread with metal core) and tide the skull making a knot inside the mouth cavity, start inserting the beads (you will need two rows in total but check if you prefer it a little longer) at the end insert the thread inside the hole in the tail bone and make another knot. see pics below.

 Wrap the whipslash twice around the Skarking body and close it passing the end of the tail inside one of the skull holes (the mandible ones).

 

Files

Comments

jjensielee

is the whiplash available for download?