Hot Wheels diorama - The car wash!! (Patreon)

Hey!!! Another one in my diorama serie: The carwash!

Scale 1/64, for small diecasts like HotWheels, Greenlight, Matchbox etc.Everything prints well on a fdm printer. Lots of details, easy to print with few supports needed.

Detailed instructions included. 7 easy steps with exploded views.You will need some short M3 screws (see instructions)

IMPORTANT NOTES:

You have two types of column for the car wash. One is slightly longer than the other, in case you have some diecasts higher than others. So the column file with "longer" in the name is optionnal.

The only parts who needs supports are the brush holders.You may have to sand some parts a bit, to ensure that they move freely.

The vertical brushes require only one screw at the bottom.The horizontal one need a screw on each side.Dont tight them too much. In fact, keep a good play to ensure the brush moves freely.

All parts already placed in the right orientation, all parts were printed and tested.

Again, hope you like it!!!! :)