Another birdhouse! For St-Patrick's day: Leprechaun's hat! (Patreon)

Yes! Another birdhouse! Made especially for St-Patrick's day! Like my other birdhouses, it's easy to print, easy to assemble and almost no supports. (A few ones, but nothing terrible and not on visible surfaces)

The design is made with 0.3 layer height for the big parts. The whole birdhouse is printable in 20 hours approx.

Use a smaller layer height for the small parts.

PART'S NEEDING SUPPORTS:

-Entrance-Buckle-Base (only for the counterbored holes, use manual supports or support blockers to have supports only in the counterbores)

Complete instructions included, with exploded views. Easy to follow.

Parts already placed in the right orientation.

NOTE: For a suspended installation, with ropes, simply drill the top part of the hat like you want, and pass a rope through the holes.Once its done, DON'T FORGET to seal the holes or else water will get inside the birdhouse.

Inside "floor" of the birdhouse is raised, so water won't get in by the bottom.

Easy cleaning between seasons, by removing the bottom part of the hat.

If you have any questions, simply message me.Happy printing!!!

Pascal