Home Creators Posts Import Register Favorites Logout
haven't archived this post yet. have a subscription? use the importer!

Content

Doing what a snail does this fella took his time getting here but he finally made it!

This is a pretty sizable monster which just makes it that much cooler on the table, it also comes with a version withdrawn into the shell because apparently it does that and cries when all it's flails get cut off?! 

As always the 32mm and 54mm versions (including pre-supported) as well as paper minis, a stat sheet and online VTT tokens have been added.

I actually done a fancy spin render this time if you want to check it out a bit closer.

Flail Snail Showcase 

-------------------------

New stuff can now be easily found here. Enjoy!

Collection/_LATEST

Collection link and current password

Pre-supported collection link and current password

Digital Hero link and current password 

Files

Previews only

Comments

Anonymous

I have attempted the print twice and each time the snail end up on the FEP and the supports print perfectly. I slowed my lift to 1mm p/sec, other prints are doing good. I imported the recommended support cfg as well. I was wondering if anyone else is having similar issues and may have some advice.

Anonymous

I had to end up adding my own supports, as it continued to rip away each time. However on the 4th attempt, using my supports it printed beautifully! I cant wait to paint him up.