Gates of Hell 4 - Hellguard A, B, and C (now available) (Patreon)

Hello everyone!

Hellguard A, B, and C are now available to Patreon subscribers. These miniatures will be available in September 2025 to Tribes subscribers.

I would like to apologize for the delay. There was 2 models planned to be released however after posing, I wanted a 3rd pose, so I created version C, the dead soldier included in A pose also took a bit of time.

Each Hellguard is a Large Demon in 32mm scale, compatible with 50.8mm round base. They will print in one go with the wings. Wings are not merged to the model; this means that you can delete them and print a wingless version of this demon. Each Model has modular hands.

Test print:

The test print used Anycubic Mono 4 Ultra, Layer 0.03mm. ABS-Like resin.

These miniatures were supported using Lychee Slicer. Lys files are included so you can tweak support settings to your needs. If you wish to support me, subscribe to Lychee using my affiliate link: lychee.co/#ae28

Best regards,

Ivo