The Dark Council - X'Avon (Testprint Feedback) (Patreon)

Hello everyone!

Today I have finished printing X'Avon, as you can see in the picture there are support flaws, so I will need to print him again. Support failures, both arms, chin, and horns.

I haven't printed a miniature and wished to redo something until now... The cape looks fantastic in the 3d and also when printed but, it's too thick, meaning that it would waste too much resin on something that does not need to (to the point where it weight almost like another 32mm miniature, just so you can see how bad I think it is).

X'Avon will be delayed because I will make some adjustments to the cape and try to make it thinner, If I can't I will sculpt another one(or at least part of it).

Best regards,

Ivo