Test Print of Miniatures - Nyla, Nassam and NightElf Hero (Patreon)

Hello everyone!

Today I took the last miniatures for this month out of the printer, without a single failure. All of these miniature were printed using Elegoo Mars 2 pro, gamer resin and  layer 0.02mm.

Nyla mounted

I will make the flying stand longer with a larger base. The way it is now, it's hard to glue on a surface and the wing were touching the ground, this might happen depending on the angle you chose to glue yours.

Nassam mounted and Night Elf Archer Hero

No issues

After fixing what I did not liked I will make the renders and release these miniatures. I expect this to be done by this afternoon (Brazil time).

Best regards,

Ivo