Welcome to the Barrens - Kram Skullgore Pose A & B (Test Print) (Patreon)

Hello everyone!

I took Kram Skullgore out of the printer and assembled him.  This resin is a bit brighter than the other that I was using so I had to tune a bit the images.

This model was printed:

Supported on Lychee Slicer

Elegoo Mars 2 pro Layer 0.03mm

Gamer Gray

LYS files are included so you can tweak the supports to your needs.

I left the shoulder pads as a separate piece on the miniature, so you can reuse in other miniatures or remove them. 

I used a simple round base and glued some sand over it.

I will now work on the render of these miniatures.

Best regards,

Ivo