Home Creators Posts Import Register Favorites Logout

Content

Hi everyone,

It's spooky season, and we thought it would be fun to make something special for the holiday. This year our team as created a printable, flexible, articulated Mummified Undead Halloween Skeleton!

This free model is available to everyone and comes in both a flexible FDM version that can print without any supports, as well as a non-articulated resin printable version. Our friends at Atlas have even made color FDM print files that you can use if you have a Bamboo printer that supports color printing, that you can see in action bellow!

Grab the models for free by CLICKING HERE!

Check out previous event models by clicking here.

These models are absolutely free for everyone, so spread the word, tell your friends, share them around, and enjoy this Halloween treat (no trick, we promise).

Happy Halloween!

- OPR Team

Note: The special Halloween model is not added to your MMF library and is only available through the download link above. Make sure to download it before it is gone!

Files

Comments

Julie

Omg the jiggle lol

Clever Username TBD

Access Denied.... Do I need to be signed in any particular way?

Andy Mull

It made me 'request access'. Weird.

One Page Rules

Try again. We had an issue with the share settings. Should be fixed now.

One Page Rules

Try again. We had an issue with the share settings. Should be fixed now.

Gatchaman

I'll keep it safe until I get an FDM printer. Then I'll scale it down to make a keychain!

The Dour Kin

Thank you so much, Samhuinn hails to all at OPR from Scortland.

JawsBFShark

Already looking at where I could put magnets or sockets next to the articulating parts in this guy. I think I could get him about 4ft tall. Hollow ABS with programmed pixel lights so the seams glow. Articulate the jaw and add a servo or two. This screamed up to the top of my too much free time list. Awesome model, thanks so much!

Josh Rodell

You could add a soul, too, if you really set your mind to it.

Paul Goldenstein

For printing on FDM do these need supports enabled?