The fourth model of the May release (Patreon)

Hello friends!

Meet one of the most difficult models to print (in my opinion) - Songbird from Cyberpunk 2077.

Now a quick note about my third printing of this character.
The first couple of times, I broke off small parts of this great model along with the supports. By the third time, I broke almost nothing and rearranged all the supports to make it easier for you to separate them — but that doesn't mean it's an easy task.

Also, I didn’t do a fourth print — after the third one, I decided to thin some of the problem areas instead of reprinting.

One more piece of advice: the most fragile parts are her fingers. So start by carefully removing the supports from them. It’s better not to break the supports off directly, but to gently separate the tips with a small knife, and only then remove the rest. The wires on her back should also be handled carefully, if possible.
The split version was the easiest to print, because we cut off some elements from her back, which made support removal much simpler.
I also thickened the bird on her arm a bit after the second print.

The model is made by SolarArt

Available on Cults3d

Also, all relevant and useful information is available in the "Collections" tab

Have a good day and successful printing, everyone!