Home Creators Posts Import Register Favorites Logout
haven't archived this post yet. have a subscription? use the importer!

Content

Happy 4th of July! Enjoy this early-access special I whipped up...I was honestly considering making this a Patron-only video, but I don't have a video for this week, so I will probably make it public on Saturday.

Files

Previews only

Building an Easy DIY Fume Hood to Save My Life

Comments

JH

Hey, do you know about govdeals.com? I purchased an amazing quality 4" labconco fume hood (with an air flow monitor system and N2/H2O/CH4/etc fixtures from ASU via govdeals- for $400! So keep an eye on there, colleges, labs and businesses are always putting cool stuff on there for amazing prices.

Dangerous Lab

Lol, can't believe you are doing all these stinky experiments without a fumehood all the time! I have a few recommendations that you might improve your fumehood in the future: 1. The height, since 2' is probably too short to fit even a regular distillation setup. (Obviously, this needs a whole remake though) 2. 195CFM is probably on the low side but should be enough given the volume of your fumehood is smaller, I used to have an inline fan with a similar CFM on my fumehood, but that was not enough output for my fumehood after doing the smoke test, ended up getting a 800CFM inline fan. You can try stress testing yours too with a rocket candy smoke test, it gives a more comprehensive test result as you can visualize the flow of smoke. 3. Getting a layer of epoxy on the interior of the fumehood, some epoxy has an excellent chemical resistance rating, that will not only prevent your fumehood from getting damaged but will also make it easier to clean and look nicer in the long run. 4. Fireproofing it, but this one could be tricky as MDF or epoxy mentioned above doesn't work well in this domain, so I guess you won't be using open flame in it anyway.

LabCoatz

So far, it's held up pretty well, although it has proven to be a little small. My distillation setups all fit well inside it (except maybe my full fractional distillation setup), and I've had a few large gas releases inside it that it handled perfectly. The first was obviously the chlorine gas in this video, which I basically used as a horribly unsafe version of the smoke test, but the second was a runaway lithium aluminum hydride reduction, which produced a lot of hydrogen and vaporized legal-meth. Some of the hydrogen even ignited in a flask, which was terrifying (although fortunately very calm and mild for hydrogen), but thankfully nothing broke. Might be for the best that LAH is so expensive... I was also planning to buy a 2x3 silicone under-sink mat to make cleanups easier, but idk. I might just go with disposable white cardstock sheets like usual, since the mat might look kinda funny on video. A larger fan is also on the agenda, whenever I can afford it...more airflow is never bad!