My Print Settings (Patreon)

Printing a Speed Runner for my personal collection. I wanted to share some of my configurations and settings so you guys have some insights as well. 

The settings in the screenshot are particularly for the Resione m58 60% - 40% anti impact on the Uniformation GKTwo printer.

Notes:

- To avoid big print artifacts I try to primarily use light supports

- Bottom layer exposure is a bit high at 40 but helps with Bed Adhesion and this is a throw away layer anyway, so no harm. 

- Layer thickness is at 4 microns which is a good balance of speed and quality. 

- For the highest quality of prints use 3 microns

- Exposure time at 2.2s is high for a printer with a heated VAT but with the higher exposure the joints will feel tighter and more sturdy. 

- Did not mess with too much of the other settings but increased the lift distance slightly since Anti Impact is a thicker resin and the resin takes longer to seep back into the vat.

Let me know if you have any questions or concerns. Thank you for checking.