KB3D Aroma Box (RB) (Patreon)

Brand new item. This small gas mask filter like device contains two chambers.

Twisting the box, which change between chambers A and B.

There are three different end plates.

To assemble, take the Aroma box base, so that the small 3 cylinders are pointing up (I.e the base should be flat against the table). take the aroma box body and gently place it on top and align the holes. the holes should be back to back with the base. if you align the holes, the one of the set of small 3 cylinders should align with the A or B in the side of the body. Now you need to push very hard to get it to clip together, this can be rather tricky. now these two are attached pick your either male or female connecter and the corresponding insert and attach it to the bottom of the base (the insert is first put into the male or female connector, then the bit of the insert which sticks out of the connector is then pushed into the base - hammer can help with this.)

the lids are then screwed on.