KB3D NEXUS Urinal - Shortened (Patreon)

As requested, here is a version of the urinal which can now fit on a smaller X1C, P1S, P2S, X2D.

The 7th Module in the NEXUS collection. The Urinal!

A unique one. A large module. This urinal uses the standard screw thread of the Nexus system to attach to the mask.

The screw thread has a barbed connector for a 12mm tube. This tube is required for the liquid to be funnelled into the mouth (if not it will just fill the mask). Or this 12mm tube can be directed anywhere.

In addition there are two NATO40 valves. which goes to urinal vents, so any scent can be captured by the gasmask. (nothing is wasted).

Although depending on the quality of the printer it should be fairly water tight, however my recommendation is to coat the urinal in a resin/sealant to seal the layer lines. This will increase the life span of the item.