Home Creators Posts Import Register Favorites Logout
haven't archived this post yet. have a subscription? use the importer!

Content

While waiting for my second fin guide to print, I decided to get back out in the garage and get to sanding. I spent a good 45 minutes sanding rvery bonding surface in as many directions as I could fathom.

After a quick wipe down with alcohol, it's looking pretty well prepped. Moving forward, I'll be wearing gloves to prevent the introduction of any oil or grease from my hands. Before bonding the fins to the airframe, I'll take some rubbing alcohol to the surfaces until the paper towels come out clean.

This flight won't be THAT extreme at a hair north of Mach 2. However, my ultimate plan is that, down the road, I'll be able to cut this airframe in half and slide in spacers to allow for longer motors to fly. Given that the electronics bay bolts to the motor case, the potential motor length is theoretically unlimited! So long as everything goes well on flight one, it'll be open to some real stress testing in the future.

Files

Previews only

Comments

No comments found for this post.