Home Creators Posts Import Register Favorites Logout

Content

Hey everyone! This week (on Thursday, this time) we're interviewing Kip Daugirdas. You're likely most familiar with his rocket Mesos, which went just under 300,000 feet on Class 2 impulse a couple of years ago.

Drop your questions for Kip in the comments below and we'll ask them during the podcast!

Comments

David Braatz

Stoked for this episode! Kip’s journey and accomplishments are truly stunning. What products would you like to see that would drastically lower the cost barrier to entry for 100k+ attempts? Can you walk us through your game plan for making an end burner if that’s still in the books? What are you using for liners and burn accelerants? After your flight to “only” 90k on Mesos, what have you done to prevent pitch roll coupling going forward? How can one change their design to mitigate this?

Neutronium

For someone who has some experience with high performance single stage rockets, what should you look out for when getting into high performance multi stage flights?

Nick Pyrtle

What are some challenges to keeping Mesos 0° off center at launch? What do you know from doing carbon layups now that you didn’t before you started doing them? Were there any special treatments to the leading edges of the fins?

Brian Kelsay

I don't know enough yet to have a question, but excited to see the interview. The launch to 293k was stunning and a great video.

Bob Green

Please give us your thoughts on the altitude trade offs of active control of roll yaw coupling in the 2nd stage. Could you walk through your experiences getting reliable second stage ignition and proper stage separation?

Bob Green

Could you share your thoughts on nozzle design? Especially interested in trade offs considered on the second stage

Rocket Vlogs

Just for clarification, here, what about a second-stage-unique nozzle are we referring to, here? Kip's stuff uses pretty standard phenolic-carrier nozzles with a graphite throat contained entirely in the hardware, so it shouldn't have much effect on the rocket itself, and I imagine it's all dependent on the motor characterization itself.

Bob Green

I was thinking more of the profile vs the material. I am sure some deliberations were had on the trade offs and optimization for the nozzle profile - supersonic at near atmospheric pressure vs burnout air pressure for example. The booster may have some considerations as well, but I assume optimizing the nozzle profile for total trust at ground level air pressure and subsonic speeds would be what is done - but it would be great if Kip would confirm that or explain why I'm FOS.