Home Creators Posts Import Register Favorites Logout
haven't archived this post yet. have a subscription? use the importer!

Content

Here's the recovery assembly for "The Bobs," on the test tube fin rocket. All in the nose with redundant Piranha cable cutters for the main.

I think I overcooked or undersealed the e-match on my ground test. It managed to blow the included Oring through the tiny hole. So, more ground testing will be done to ensure I've got the setup situated.

I also want to try to implement a way to get the zip ties into the nomex so the burley charge cannons don't cook them at apogee. I'm not trying to have my main out at 50k on the N1000 flight 😬

If anyone has any cable cutter advice, fire away!

Files

Previews only

Comments

Jeremy Sim

Ditch the o-ring around the ematch and move yo the blu-tac method. Works for me every time. Also I use some small kevlar to secure the cutter to my rocket. I have had the cutter break loose after dragging on the ground after the rocket landed

Kevin Turner

Looked like too much powder.

Aleks

I second hot glue. I have used it several times with the oring and never had a leak. Also, a tip I got from Cameron Tinder when I asked about zip tie sizes was to instead use 2mm waxed cotton cord so as to not drop zip ties on the launch site. I’ve had great luck with that as well.

Kevin Turner

After watching the full video, the amount of powder used was correct. I personally don't care for the blu-tack method. Hot glue has been my goto method.