Home Creators Posts Import Register Favorites Logout

Downloads

Content

May 3rd : there was a "bug" in the F634 & F625 files, which are now updated. So now all versions have been tested and safe to use. Slide

May 3rd :there was a "bug" in the F634 & F625 files, which are now updated.So now all versions have been tested and safe to use.Slider have not change issue was on the shell, but have added a new slider using M4 screw on the F634 version

-------

This is the same X tensioner design I designed and used on the mini XZ plate belted setup but adapted to stock front XZ plate, whether it's a completely stock ender3/pro/v2/3max or with wheel or Z rail, z screw or z belt as long as it has the stock front XZ plate.

stock belt should remain compatible (on rail apollo you might need to adjust the belt holder notch)

the thickness of the XZ stock plate is slightly different so there are two slightly different models for ender3max/3maxneo vs other ender3/pro/v2

The tensioner is only 20mm thick, so flush with the top/bottom of the extrusion, work with X wheels or X rails.There is no bumper for x rails so make sure to set a X max in klipper (if you ant a bumper let me know, I can add it to the part)

-----

Slider tolerance are tight, don't worry if it doesn't slide smoothly by hand, once under belt tensioner and opposite screw pulling it will slide just fine.

If you get some light squeaking on the pulley, add a tiny amount of grease on the inner wall of the GT2 pulley.

-----

unless my previous design with M5 screw, this uses a 5x20mm dowel (if you get a cheap pack, the tolerance on those is hit or miss, so if one doesn't fit the GT2 20t pulley, try another, only happened with one)

GT2 20 toothed idler pulley with 5mm bore for 6mm beltamazon - aliexpress (5mm with teeth - 6mm belt)OR stock idler - F634ZZ

5x20mm dowel:amazon 50pcs - amazon 20pcs - aliexpress (M5x20) - aliexpres M5 assort.

M4x30 socket head screw:amazon M4 pack - aliexpress M4x30

two M3x12 socket head:amazon M3 pack - aliexpress M3x12

two M3 x 4mm Length x 4.6mmOD or 5mmOD knurled heat inserts

stock M4 front countersunk screw

stock M4 rear screw

Side note:

My favorite solder iron: Pine64 Pincil (amazon) - heat insert tips (amazon)You just need a USB C power brick with PD (60watt for full power), if you have a recent MacBook pro (and I'm sure PC laptop with a USB C brick) you can use the power brick from those.Otherwise something like this amazon (no idea if this is good or not, just an example )Also a silicone USB C cable is recommended in case you accidentally touch the iron to the cord.

I set the iron to 230C usually, for PLA or PETG. you can also remove them (it's destructive for the printed piece most of the time, by heating up the insert until it just barely start to move, and use a long screw to pull it out, with practice you can get those to come out clean)

------

Files

Comments

Patron of the unknown arts

Hi, awesome tensioner. I just noticed the g20 pulley kinda wobbles and i believe its cause me some banding issues. Should i re print the sled?

Squirrelf

yeah I definitely would reprint it. if your next one still wobbles I can make you a slightly tighter one