Enclosure for Octopus v1.1/pro/ezmax and stock/BTT SKR e3series (ender3pro/3v2 and e3max) (Patreon)
Content
Files are on the store page (here) , STEP file included
-------
Updates:
March 21st:
dedicated ender3max version that is 40mm longer
Middle front optional foot
-------
side note:
The Octopus v1.1 and Pro are slightly older model but offer the best bang for the buck in term of board. Lots of fan port and endstop ports and as you can see fits well!https://s.click.aliexpress.com/e/_m0Bpmnd
Other notable boards (can easily make a model for those mounting pattern)
SKR pico (only 4 drivers, like SKR mini e3v3)
BTT Octopus EZ max is worth looking into same pointing pattern as octopus pro and more recent (up to x10 EZ driver)
BTT SKR 3 EZ (up to x5 EZ drivers)
BTT SKR V1.4 Turbo — old but one of the cheapest 5 driver board (will make amount by request), limited fan port, only two (only one with controllable speed)
BTT SKRat (x5 drivers and modern, only downside is slower MCU same as SKR mini. e3)
BTT Manta E3EZ (up to x5 EZ drivers)
BTT Manta M8P V2.0 (not 100% sure it will fit,but if interested let me know I can take a closer look ) (up to x8 standard drivers)
---------
(x40) 6x3mm magnets (Amazon)
M5x8mm + T-nuts (M3 and M4 setup by request)
M3x8mm
I made this fully done with screw in plastic to save on heat inserts, as assembly should be limited to one time with no disassembly needed (though can go through full disassembly a few times without issues). The rest is on T-nuts or magnets, so no wear.If you do want a threaded heat insert version, let me know.
The bottom is secured to the extrusions via t-nutsFront and top panel are held with magnets, making it easy to access
There's always room for improvement, but works great as is (tested on ender 3v2, and will soon be setup on an ender3max neo)
Modularity allows for partial reprints!
Major wiring should be done during install, but easy access can be useful at times
right side has mounting point for a raspberry pi, and additional one to mount buck converter and suchCouple fans mounted under the Y extrusion to cool down the stepper drivers
Feet included (re-uses stock rubber pads, but I also included a printable model that can be printed in TPU)
As always, no print support needed, and all fit on an ender3 bed (longest side is 203mm)
Ethernet cable going through the side extrusion
Pi powered directly by the octopus and klipper setup for UART communication