"Ultimate" ender bed belt clamp - ender3pro/v2/max (Patreon)
Downloads
Content
This not meant for your stock belt, but in the event that you swap it to a fresh one.Disclaimer: After install there's a small chance that a belt tooth will jump in the S pattern around the bed belt cutout leading to a layer shift before it settles correctly, make sure to run a resonance test a couple times. or print something small with a bit of speed/accel to force the possible tooth jump as early as possible.But ideally you should always run a resonance test after swapping belts/re-tensioning (I didn't do so, and had a layer shift after 1 hour of printing, I'm not 100% sure they were the cause, but it is my guess, after that it settled correctly, and have multiple hours worth of printing with no issues.).
M3x6 + heat inserts (m3 x 4mm L x 4.6mm or 5mm OD)
Regarding the screw length the added thickness is 4mm from what you had before.
if using stock wheels M5x34mm (or M5x35mm
if using my linear rail setup, you would need M5x16mm
if using my linear rods setup, you would need M5x34mm ~ M5x35mm
Print in PETG of betterSupports ender3pro / 3v2 / 3max 3max neo bedsthe difference is likely small, but for better precision best to have the belt through the bed belt cutout like stock belt was, see render.