Home Creators Posts Import Register Favorites Logout

Downloads

Content

For anyone running my z belt clamp, here is a small tweak that will further solidify the setupSince the Spring/Screw is off center, the tension of the belt applies a slight twisted motion on the slider block once tensioned. And can wiggle a bit. it would find its resting state and work well from there, but this would stop such potential movement.And as a bonus allows tweaking the tension for both belt to be absolutely matching — with springs I was noticing a 1~3hz difference, which was seemingly close enough, but now can twang in perfect unison.Only the outer piece changes, so it's a relatively quick swap front screws should now be M3x10 or M3x12 (used to be M3x8 or m3x10)the new vertical screw should be M3x20 or longerand an M3 heat insert on the lower piece.On a semi-related note: the MiniXZ plate setup (as of April 18, 2025), has an updated X motor mount (motor side front XZ plate) + Pulley cover. Meant to be more resistant to the radiating heat of the X motor.

Files

Comments

No comments found for this post.