Phaetus/D3vil Design DXC extruder now supported on Apollo (Patreon)
Downloads
Content
I made two model of the mount one meant for the Sherpa Backplateother for the Orbiter2 backplatehttps://www.phaetus.com/en-us/products/dxc-extruder
The motor is not included as it's meant to be a drop in replacement for the Creality K1 extruder. Needs to be 12t gear (the common motor for Sherpa and Orbiter uses 8t/10t) Got mine on amazon, rated 1amp AmazonFystec also sells a 12t for the K1, can be found on amazon/aliexpress but rated only 0.8amp, so would pick the 1amp instead, to match the original motor.
The wire order on the motor I got needs the middle two wires to be swapped, motor -> Black/Red/Orange/Blue --- cross middle two -> Black/Orange/Red/Bluecheck continuity with a multimeter, Black & Orange should show continuity (beep)same with Red & BlueThat is the common wire order on a creality/BTT board - tested that way on an BTT octopus pro board.BUT may not always be the case so always double check with the board (especially CAN type or LDO board, they seem to make thing different)
Use M3x8 or M3x6 to secure the mount firstThen slide in the extruder + PTFE and three M3x4 screws for the sides, bottom screw can also fit M3x6, but top right side has to be a M3x4.You need to press down on the extruder as you secure the side screws, but that means it will be very tight and secured!
This is a self tensioning system, so the tensioning screw actually release pressure, so needs to be as unscrewed as possible. basically lightly tighten, then when the spring start compressing only do 1/4turn at most.Klipper values:rotation_distance: 6.8~6.9after calibration mine ended up being 6.9322
run_current: 0.55~0.600.7 was a bit toasty, measured 70C after a 40min print.extruder accelerationmax_extrude_only_accel = 5000~10000 (did 10000 so far and seems fine)retraction/deretraction I have at 120mm/s and seems fine.