Apollo to Sovol SV06 (linear rod) prototype (Patreon)

In case any of you have a Sovol SV06, here is preliminary direct support for itI don't have one so this should be considered a prototypeThis is meant to be used with the linear rail model of the Apollo with the universal main bodyThere are two preliminary option

Option1:

Meant to be used with the PCB and metal plate3 screws behind the metal plate (instead of holding the stock extruder would hold the adapter.) then mount the Apollo onto the adapterTwo thickness option. one that clears the Apollo from touching the Z screw mount, other doesn't clears it, incase it doesn't need to clear it. or to reduce the Y offset in case of lost printable Y area

sovol_apollo_rail_13.5mm.stl

sovol_apollo_rail_7mm.stl

Option 1.5

Same as above but with M12 probe integrated  (was pointed out that this printer comes with one)Offset is X=20, Y=23.5~29 (depending on hotend used with the apollo)

sovol_apollo_rail_13.5mm___M12_probe.stl (updated Feb 22, 2023)

Options2

Remove the metal plate and PCB, but also the front linear rod covers, as this piece replaces is. The nozzle is roughly at the same X~Y position as stock, but moved up 4mm to get the top of the Apollo flush with the top of the rod mount, hopefully those 4mm will still allow the Apollo to land and touch the print bed (in case the Z screw mount hits the piece at the bottom first ) , kinda of a bummer if the ApolloLander can't land...This is based on official Sovol cad files, so hopefully they are correct.Apollo_Sovol_sv06_direct_mount.stlabove file is preferable, but if the nozzle doesn't reach, this below should work, but you loose the ability to install an orbiter extruder with rear motor as is, would need a 4mm riser so if that can be avoided that would be bestApollo_Sovol_sv06_direct_mount_alternative_just_in_case.stl