[Archived] Yeti Flexi and Mountain Shelf (Patreon)

Hiii!!

Its Yeti Day!!! Yaay!!! Everything that is included in this release:

❄️ Yeti Flexi and Keychain
❄️ Prepainted 3MF
❄️ Mountain Shelf (2 parts)

Yeti flexi was tested down to 80%, I would not go smaller than that because the legs start to catch at lower scales. I don't recommend scaling the keychain version down at all as its already scaled down.

In the 3MF the regular sized yeti is split to parts, while the keychain version is not.

Please make sure that when you are editing the 3MF of the regular yeti that you are NOT painting the eyes, mouth, and foot pads with the paint tool. They are split to parts and painting them will create uneven paint lines. Instead please assign color to them from object list located in the left side panel.

The shelf/stand prints in two parts, the peaks print separately and should be glued onto the tops. It can be used as a stand, or hung on the wall using two nails at the peaks. 100% shelf fits 100% yeti.

⭐As with all of my designs, I strongly advise that the printed models are not to be handled by children under 3 without proper supervision⭐

Filaments used: 

White Yeti: Polyterra Cotton white, Polyterra Pastel Ice, Ziro Twilight matte Gradient
Rainbow Yeti: Eryone Matte Rainbow, Ziro Starry Sky, Polyterra Army Beige
Blue Yeti: Cookiecad Blue Omber, hand painted accents.

This design has been Archived. If you were subscribed the month which this design was released then it will be free to download from your My mini factory account.

If not then it is available to purchase from the below links. Patreon License still applies to designs purchased separately. Make sure to use the discount code listed in the download post 

Cults3D

My Mini Factory