[Exclusive] Heart egg and Cupid Snake Short (Patreon)

hiii!!

I am working on the next release! I should have a sneak peek for you guys tomorrow! In the mean time I've got two exclusives!

The heart egg was requested by a few of you! The egg is a twist closure. I have included a tolerance test for the top of the egg. You can print the bottom and then if you wish print the tolerance test of the top to see if you need to scale the top of the egg up or down depending the tolerance test result. I recommend scaling 0.5-2% depending on how loose or tight the egg is.

I recommend changing wall generator to "Arachne" to print the eggs (bambu slicer or its derivates)

80% Cupid snake fits into 100% Egg. You can fit two 80% cupid snakes on the A1 mini by rotating them diagonally. Tested down to 60%, I wouldn't go smaller.

⭐As with all of my designs, I strongly advise that the printed models are not to be handled by children under 3 without proper supervision⭐

If you are having adhesion issues with the cupid snake, Make sure that you are starting with a clean bed (good scrub with soap and warm water, not touching the printing area with your fingers at all ever) and adding a brim with a brim gap of 0.3

No supports! 3MF files included.

This is a patreon exclusive release. Patrons can download it free from the patreon exclusives link in the download post!

-----> Current download post <-----