[Exclusive] Bottle Terrarium - Puffypuff Collabration (Patreon)

Hii!!

I am happy to share this collaboration with PuffyPuff! It was so lovely to work with them and I am obsessed with all of their creations so please make sure to check out their patreon - PuffyPuff Patreon

✨ Fungo ✨

• 3 walls, 15% gyroid or 3D honeycomb infill. No supports.

• I don't recommend going smaller than 100%, Tested up to 200%

• We strongly recommend printing Fungo and all the split parts with 0.12 - 0.1 Layer height. He is small and prints much better at these smaller layer heights. However he is still printable with 0.2 layer height.

• The eyes and cheeks should fit flush to the face as shown in the pictures above, if they are sticking out at all you may have put them on the wrong side.

• 100% Fungo fits inside 100% terrarium

✨ Bottle Terrarium ✨

• all the parts can print at 2 walls, 15% gyroid or 3D honeycomb infill. No supports.

• Switch Wall generator to Arachne for all the parts of the terrarium

• Infill can be turned off for the bottle.

You guys had requested a clicky version of fungo, Puffypuff was kind to make one!! Its avaliable on their patreon - PuffyPuff Patreon

⭐As with all of my designs, I strongly advise that the printed models are not to be handled by children under 3 without proper supervision⭐


 +++ This is a patreon exclusive release. Patrons can download it free from the patreon exclusives link in the download post +++

✨✨-----> Current download post <-----✨✨