Mickey Mouse Clean (Patreon)
Content
RESIN
45 DEGREE ANGLE
DENSITY 75 PERCENT
FDM
LAYER HEIGHT 0.28
INFILL AT 20 PERCENT
STANDARD SUPPORTS
GYROID PATTERN
215 NOZZEL
60 BED TEMP
60 MM/S
SUPPORT NORMAL / OVERHANG 50
SUPPORT PATTERN LINES
He printed on the fist try with no issues but after a particularly difficult battle with some supports, resulting in mickey losing a finger and half of his tail, I decided to also include the tail separately in case anyone else runs into the same problem. After a little sanding and some careful placement you'd never know. Thankfully he stands fine without the tail so I wouldn't worry if you cant get it perfectly accurate to the floor. With it being so thin its a little temperamental but it did print fine 5/6 times with a brim enabled and the speed reduced to 40.
Any questions or issues please drop me a message, I'll be happy to help. Stay tuned for ornamental variants and a final model update including painting details and photos!
Thanks again for subscribing!
Harley