Home Creators Posts Import Register Favorites Logout

Content

The first version of Meeko is now available below! I printed him at 16cm tall so he's a little taller than Remy, he also has no thin or fine areas so there shouldn't be any problems printing on either Resin or FDM.

RESIN

45 DEGREE ANGLE

DENSITY 75 PERCENT

FDM

LAYER HEIGHT 0.2

INFILL AT 20 PERCENT

TREE SUPPORTS

GYROID PATTERN

220 NOZZEL TEMP

60 BED TEMP

65 MM/S

SUPPORT NORMAL / TOUCHING BUILD PLATE

OVERHANG 45

SUPPORT PATTERN LINES

Any questions or issues let me know! I'll be working on the Ornamental version throughout tomorrow so with a bit of luck he should be up on the page tomorrow evening.

See you in the next post,

Harley

Files