Home Creators Posts Import Register Favorites Logout

Content

The scaled version of the dragon is now all ready to download below! again I've set the model at 17cm tall which makes her a couple of cm bigger than our Lotso model. She should print fine on resin or FDM but a drain hole is recommended for the end of her tail to prevent suction issues and organic supports are recommended for her spikes and mouth.

RESIN

45 DEGREE ANGLE

DENSITY 75 PERCENT

FDM

LAYER HEIGHT 0.2

INFILL AT 20 PERCENT

TREE SUPPORTS

GYROID PATTERN

220 NOZZEL TEMP

60 BED TEMP

65 MM/S

ORGANIC SUPPORTS / TOUCHING BUILD PLATE

OVERHANG 45

SUPPORT PATTERN LINES

Any questions or issues let me know! The ornamental version should be out sometime throughout tomorrow!

See you in the next post,

Harley

Files

Comments

No comments found for this post.