Statusupdate on issues (Patreon)
Downloads
Missing 1 file, as this post has not yet been imported.
Content
Today I want to give an update on the problems I found after doing my test prints:
1. Assembling the motor towers was a nightmare. It's not technically a problem, but I had a really bad time assembling the motor towers. When I built the towers, I made sure that the free space was large enough to accommodate all the cables with their print heads, but I forgot that fingers are wider and it was really a struggle to fiddle them through without them interfering with the airflow. So I changed the internal design to have small cable channels where the cables could be fixed, making it easier to insert the motors.
2. On 3/4 of the motor towers, I placed the temperature sensor where their heads were in the airflow. This could be a problem as I didn't want the airflow to cool the temp sensors. So I changed the position of the sensor so that it was directly under the fan duct and therefore covered. So I have to re-print the lower part of the motor tower.
3. Distance problems: I had to add two washers because there was too much space between the fans and the fan cover, causing the fans to rattle when the tower was shaken. I've changed this in the parts so it shouldn't be a problem for you, but I won't reprint it for me.
Overall all green parts are fine, the yellow ones have to be reprinted and the grey parts are still on my todo list.