Home Creators Posts Import Register Favorites Logout
haven't archived this post yet. have a subscription? use the importer!

Downloads

  • 335317055.txt

Missing 1 full-res photo, 1 file, as this post has not yet been imported.

Content

We are approaching the finish line, almost all the frame parts are printed, there are a few panels left, the side fans, the power supply brackets and the bottom cover... I force myself not to print the gantry, knowing that it will be a pain to wait for a boring side panel when the main parts of the printer are already ready for testing.

Here is an overview of all fixes that I've made while testfitting:

  • Set screw tolerances for heat inserts to 3.7mm

  •  Motor connector slot width increased by 4mm

  • Improve cable routing in motor towers

  • Motor Tower Back Right wrong Screw hole in Gantry Motor Connection

  • Right Idler wall too thin

  • Clearance front idler clamp

  • Tolerances Y XY Joiners

  • Side blower cable guides rework( cable squeeze protection)

  • Cable Channels front motor tower too thin

  • Added Cable guide Heatbed

  • Bottom frame parts elephant foot compensation

There is still a bit left to print:

Files

Previews only

Comments

SoLo

What made you go with rods and bushes over linear rails for the X?

The100

They are about twice as fast as linear rails at accelerations above 80k. A linear rail only supports movement in the axis it is designed for, so if you only want to move the printer in X, a rail would be faster, but as soon as you move the X rail in Y, forces of 10-15g push against the carriage on the rail, dampening performance. In a linear bearing you have 4 ball tracks, one every 90°, so in the worst case you have one ball track supporting the movement in X and Y, and on average two if you have the bearing in the right orientation in the carriage.

SoLo

Thanks for the explanation man. Looking forward for the BOM and print files! Excellent work mate

tanner briton

I've been noticing that there are a lot of parts that are split up and screwed together that look like they could be printed in one peice. What is the size of printer you are using?