Release of my THE 100 LM8UU linear bearings (Patreon)
Content
Those who visit my booth at Makers Faire, might notice that my XYJoints are kind of special. Look at those black LM8UU. Those are the 3rd generation of own designed linear bearings.
About 4 months ago I started developing my own linear bearings together with FUSHI. After researching over 15 different manufacturers of linear bearings, I came to the conclusion that the quality of most of them was not good enough for speeds over 300mm/s. Almost all participants had one of two problems:
- Tolerances were not accurate enough, causing vibrations
- The steel balls inside the bearing were too rough and therefore generate too much friction, which leads to heat generation, thus expansion of the body and again to vibrations.
I had the idea to harden the steel balls inside the bearings and together with FUSHI we designed a manufacturing process that uses chrome plating to:
- increased the hardness of the steelballs by about 30% which increases the longevity by about 300%
- reduced the friction of the steel bearing at highest speed by about 30-40%
Also we decided to coat them black since I have a favour for black ;-)
Those 3rd generation bearings I used in my 1500mm/s at 35k acceleration on THE 100.
A couple weeks later we finalized our 5th iteration on the LM8UU and decided that It's time to extend the test group. We produced a small batch of 250 LM8UU and 250 LML8UU to get halfway good prices, so if you like to test them, feel free to get a pair of each and give us feedback here at this patreon post.
I would recommend the following config:
- 2x LM8UU for X-Axis
- 2x LM8LUU for Y-Axis
With that said, happy shopping
https://s.click.aliexpress.com/e/_DDwD9oX
Please do not share the link to public. We don't plan to create another batch soon. This is a goodie for you guys that support me and the project and it would be a shame if some of you don't get a pair because they're sold out.
Files
Previews only