Home Creators Posts Import Register Favorites Logout
haven't archived this post yet. have a subscription? use the importer!

Content

Hello Patreon's

in the last 3 weeks I was at a workshop of a friend. Together we worked on new type of Hotend. I have 2 designs that are pretty promising that I will test in the next few weeks on my printer. Both designs are able to melt ~200mm3 of PLA at 250°C with a 0.5mm nozzle.

In the old days of printing we used 2,85mm filament and we decided to build a Hotend around that filament type. We combined it with the CHT Splitter. This gets us 3 filament strings at the mass of ~80% of a 1,75mm filament.  To split the filament we had to invent a pre heater that heats the filament to a certain temperature. Too hot filament would make retraction impossible, to cold filament make the filament unable to be splitted. 

After the splitting was done we have 3 filament streams that get melted by 2 heater cartridges. 

Our test results were great. One version reached 230mm3 of flow the other 210mm3. To be able to print with that Hotend we need to write an own Klipper plugin since klipper does not know what a pre heater is. Also we have to tell it the temperature that it should use for the filament type.

So there is a lot of work to do until we are finally able to print something with it. 




Files

Previews only

Comments

Krzysztof Wierzbicki

I just calculeted it quick. About 200mm3/s woild take You down to about a minut to pump out enough filament for a benchy. Can’t wait to see that contraption at work.

Andrei Ignat

Martin Nitram, creator of VolcoMosq also used preheating a couple of years back. He might offer some insight.