Home Creators Posts Import Register Favorites Logout
haven't archived this post yet. have a subscription? use the importer!

Content

Today I started prototyping the back frame parts for v2.0. I want to make them as stiff as possible and also hollow, as the infill does not add much to the stability of the part. This will allow us to move all the cables inside the frame and also save a bit of filament.

But there are also some pitfalls to solve:
- find good tolerances that work on most printers
- find joint pattern that is rigid, easy to print and flexible enough
- hide joints to keep the aesthetic of the printer

Since that topic is pretty new to me (for woodworking I always used dovetail or finger joints) I would like to get your opinion on that topic. Are there better ways to joint that parts? Do you have articles/studies/videos on joints? Let me know in the comments.

Files

Previews only

Comments

Krzysztof Wierzbicki

Sweet. That’s a cool idea to have the cables inside. There’s so much great Japanese joinery to inspire off of. When it comes to tolerances for most printers, old saying goes: “If you can’t make it perfect, make it at least adjustable”

Zach Mitchell

Few things to think about with this. You can add inside void blocks to make parts more ridged as it will creat more walls there. But print orientation is still critical. Holes and vertical structures even with these voids to increase rigidity will still fail if the require torque or shear point is a long the layer lines. Might want to look at CNCKitchens layer temp test and cross it with cubic multiwall infill to get super rigid high torque resistant parts.