Patreon Exclusive: Jack-O-Lantern Set! (Patreon)

***THIS FILE IS NO LONGER INCLUDED FREE WITH SUBSCRIPTION.It can be purchased once re-released according to this Schedule.Hey Everyone!  Here's something a little different.  I wanted to get one last Halloween themed model in before we get too far into the month, so this is my take on the classic Jack-O-Lantern!  There are five different printing options included in this set:

1) Ornamental version  

2) Lidded Candy Dish/Bowl

3) Lidded Dish with Cut out Eyes, Nose, and Mouth

4) Keychain 

5) Refrigerator Magnet (this one has a 90 degree corner, so could be printed bigger as a decorative piece to put flush against a wall) For magnets use 10mm x 2.6mm magnets like These On Amazon.This was a really fun sculpt to explore, and making a lidded dish was a lot trickier than I anticipated, haha!  I hope you enjoy it!

*Click Here to go to the Pinned "the Hub - Info and Current Download Links" post*

*The Jack-o-Lantern Set will only be available as a free download until November 30th. Will be available again in March 2023, for purchase.

Printing is pretty straightforward. Most variants shouldn't need supports*, unless you want some inside the mouth.  I found the overhangs performed fine without them.*the cutout eyes, nose, mouth version will need supports!

-5%-10% infill should be sufficient.

-Magnet: I would use 10% Lightning Infill like all magnets, to keep the weight down.

*Click Here to go to the Pinned "the Hub - Info and Current Download Links" post*

*The Jack-o-Lantern Set will only be available as a free download until November 30th. Will be available again in March 2023, for purchase.