Hazard Stipe Roller (Patreon)

Hey Miniature Makers!

This week, we made a tool for adding hazard stripes onto vehicles, minis, and terrain.

It will work with all putties, but is specifically designed for use with two-part epoxy clay. To use it, it works best rolling out the epoxy onto non-stick paper and then rolling the texture over the top. After this, trim the hazard stripe you want to use off and stick it onto your model.

Unfortunately, my epoxy clay had dried out and gone a bit odd, so I used some air-drying clay here to show roughly how it works (ignore where it is a bit crumbly on the bends, as this won’t happen with epoxy clay).

There are four different sized hazard stripes on the roller, so you can choose the size that works best for each model.

INCLUDES:

• Hazard Stripe Roller

As always, they come laid flat for FDM and fully pre-supported for Resin printing!

How to Download
Now added to your MMF library for September

Keep on Rollin'
Simon & Justin