Home Creators Posts Import Register Favorites Logout

Content

I throw out 5 free models to the general access. Please give feedback PM

https://drive.google.com/drive/folders/1Byvw9x63Kkb660FjYuLGTXBAdV7gyi3R?usp=sharing

Files

Comments

Tharehl101

Model one doesn't have a belt on its front side. Model 2 failed to print 2 times. Printed the others fine. All seem a bit undersized to me, used 28mm scale ragdoll to test next to.

GGW

Are these test models. I check everything before release. What printer did you print to?

Aevox23

Hi, new Patron here. Is there any way to receive/purchase rewards from previous months? If so how does that work? Thanks.

GGW

Until there is a new release, the old release will remain in effect.

GGW

Models updated. Everything is fixed

Tharehl101

Sorry man I have 2 printers a mars 2 pro and a Saturn. I always have problems with pre supported models. This is why I always do my own supports. But, there wasn't any that wasn't supported to test with. I tried the 2nd model on both printers and failed on both. I'll re-download the new files and try them again later tonight. Not at home right now sorry man.

GGW

How to get tell what happened?

Tharehl101

Re-downloaded and re-printed new files and file 2 sword failed but could be my setting I use really fast settings. This is one of the reasons I always use my own supports. Model 1 looks good now and printed fine.

Harold

Will you be sending out another set of stl files where the figure, weapon and the base are separated I use other bases and dont want to waste resin on bases I will not use

GGW

Bases are already separated from models everywhere.

Harold

What I downloaded bases was on the stl file only the sniper did not have base but all others had figure weapon and base all on the same stl

GGW

The stand is separately in the folder. Well, if you send me a PM, I'll send it