Creepy alert!! (Patreon)
Content
Have 3d printed them, glued the halves together and put some small screws in the base that wont be seen so they can stand off the table. I won some XTC-3d in a facebook contest (great timing), so applied a coat of that to help smooth out a lot of the layer lines. This stuff is great! It's a brush on, self leveling resin. It really helps remove a lot of the sanding work. I still had to sand a LOT, but much less than usual.
Currently have them 90% sanded (been sanding all day). They are drying after a 3rd coat of primer. Once they are completely smooth I'll make a mold and cast them out of hollow resin. That way I wont need to do any painting at all, since the resin is white. I can also make copies if I mess up.
I'm not sure if I want to print the top teeth again and make them wider (not taller)? They might need to come back into the jaw a little more. I'll think on it
Files
Previews only